Use
screw-eye provided to enlarge
the vent hole on the top of the
cartridge.
Take
the bottle and push the needle
slowly into the sponge, taking
care not to squeeze the
bottle.
Inject
the ink slowly, pulling back
slightly as you inject, to
expose the different parts of
the sponge to the ink. Remember;
a little ink goes a long way!
The cartridge takes approx
20-22ml to fill. Only inject a
few mil at a time, using 2/ 3 of
the bottle and allow to stand
while the ink soaks in the
sponge.
When
the sponge is full, wipe the
printhead, and return to the
printer.
Run
the head cleaning process
through the printer software.
Carefully
using a knife, prise the cap
from main body of
the cartridge.
Once
the cap has been removed, the
sponges are
exposed. Take a bottle and
insert the needle, through the
hole in the plastic and into the
correct colour
sponge.
Inject
the ink slowly, pulling back
slightly as you inject,
to expose the different parts of
the sponge to the ink. Make sure
that you have stopped injecting,
before
reaching the top of the sponge
or the colour make leak into
another sponge. Remember; a
little ink goes a long
way! The cartridge takes approx
7ml of each colour to fill. Only
inject a third of the bottle
each refill, and allow
to stand while the ink soaks in
the sponge.
When
the cartridge is full, put the
cap back on and attach with
sticky tape.
Wipe
the printhead, and return to the
printer.
Run
the head cleaning process
through the printer software.
Prices listed on this
website are in British Pounds (£) and are inclusive of VAT. This website
is managed by Inkraider.co.uk. All brand names and Trademarks used
here are for identification purposes only. These names and Trademarks
belong to their registered owners.
Ink Cartridges
